SensorData Sigfox
Sigfox Data-Logger with SDI-12, I2C, Digital Inputs, Analogue Inputs, GPS, Ultra-long Battery Life, in a Waterproof Housing
SensorData is a battery-powered data communicator that interfaces to a range of sensors, GPS, inputs and outputs, and uploads data via the Sigfox network. Great for agriculture and remote sensor monitoring applications.
FEATURES
- Up to 5 years once daily update
- Up to 2 years of hourly updates
- SDI-12 interface to soil moisture probes, temperature, EC and others
- I2C interface for a wide range of sensors including: Temperature, Humidity, Vibration, CO2 gas and many others
- Configuration via USB cable and over-the-air Sigfox downlink messages
- 2 x Analogue Inputs with auto range
- 3 x Digital Inputs
APPLICATIONS
Mechanical Features
|
Low-profile IP67 rugged housing |
The IP67 rated housing is made of sturdy ABS/Polycarbonate plastic to survive bumps and knocks and many years in the sun and weather. It is low-profile and caters for a number of cable glands to allow for waterproof cable entry to the housing. The housing screws together for easy assembly, and has convenient mounting tabs. |
| Operating temperature |
-20°C to +60°C For operation in extreme temperatures the device must be fitted with Lithium batteries |
| Dimensions (mm) | L 183 x W 145 x H 40 |
Interfaces
|
SDI-12 |
This interface is commonly used in agricultural sensors and measurement devices for soil moisture probes, temperature, electrical conductivity (EC) of soils, water levels / pressures, other SDI-12 probes and sensors. |
| I2C Interface | I2C (inter-IC communications) is an interface commonly used in sensor modules. This allows the SensorData to talk to a wide range of sensors including: temperature, humidity, vibration, CO2 gas and many others. Speak to Digital Matter about sensor support. |
| Digital Inputs |
3 x digital inputs, 0-48V 2 provide low power pulse counting |
| Analogue Inputs |
2 x analogue inputs, 0-30V with auto-ranging Built-in battery voltage monitoring |
|
Network |
Sigfox (LPWAN) Sigfox Zones RCZ1, RCZ2, RCZ4 |
| External antenna | External ISM band antenna provides for maximum link budget with the flexibility to install a high-gain antenna if needed. Especially important for long range in rural agriculture applications. |
| Power (4-6V) | The SensorData is ultra-low power and is designed to run off a set of 4 x “C” cell Alkaline batteries for a full season. This includes powering the sensors and SDI-12 probes. These off-the-shelf batteries are low cost and readily available. It can also be powered by a USB 5V wall socket if permanently installed in a location with power. |
|
Switched Sensor Power (6V or 12V) |
Used to control the battery power to external sensors and peripherals. Load limited and short circuit protected. 12V capable boost is available to supply SDI-12 sensors, especially over long cable runs. |
| 3.3V Switched Power | Used to control the 3.3V power to external sensors and peripherals. Load limited and short circuit protected. |
| GPS | The optional GPS module allows the SensorData to periodically update its location and time. Know the exact position of your sensors, and obtain an accurate time update. |
| Configuration |
Via USB cable for firmware updates. Via over the air (OTA) downlinks for configuration |
| Test Button | Convenient to test installation and wiring. |
| Status LED | Visual feedback in the field for testing |